How Is A Back Clip Harness Correctly Fitted?

A back clip harness is an essential piece of equipment for any dog owner. Not only does it provide a more secure comfortable fit than a traditional collar but it also helps to prevent injury to your pet’s neck.

Step 1: Measure your dog

The first step to fitting a back clip harness is to measure your dog’s chest. You can do this by wrapping a tape measure around the widest part of their chest just behind their front legs.

Step 2: Choose the right size harness

Once you have measured your dog you can choose the right size harness. Most manufacturers will have a size chart on their website or packaging so you can easily match your dog’s measurements to the appropriate size harness.

Step 3: Adjust the harness straps

Once you have the right size harness you need to adjust the straps to ensure a proper fit. Start by loosening all of the straps before putting the harness on your dog.

Next slip the harness over your dog’s head then slide each leg through the appropriate opening. Adjust the straps until the harness is snug but not too tight. You should be able to fit two fingers between the harness your dog’s skin.

Step 4: Clip the leash

Once the harness is properly fitted clip your leash onto the back clip of the harness. This will allow you to have better control over your dog prevent them from pulling or straining on their leash.

Final Thoughts

It is important to remember to always supervise your dog when using a back clip harness as some dogs may try to wiggle out of the harness if it is not fitted properly. Additionally never leave your dog unattended while wearing a harness.

By following these simple steps you can ensure that your dog’s back clip harness is fitted properly provides the best possible comfort security while walking or running.