H2: Introduction
SharkBite fittings have revolutionized the plumbing industry with their simple quick easy installation process. Unlike traditional copper fittings SharkBite fittings do not require any soldering or special tools. That being said installing SharkBite fittings on copper pipes is an easy DIY project that you can accomplish with just a few basic tools. In this article we will guide you on how to install SharkBite fittings on copper pipes.

H2: Materials needed
Before starting we need to gather the necessary materials for the installation. The following are the materials required:
– SharkBite fittings
– Copper pipe cutter
– Emery cloth or sandpaper
– Deburring tool
– Measuring tape
– SharkBite depth gauge
– Sharpie or other marking tool

H2: Steps for installation
1. Measure the copper pipe
– Use a measuring tape to measure the length of the copper pipe where the fittings will be installed.
2. Cut the copper pipe
– Using a copper pipe cutter cut the copper pipe at the measured length. Make sure to cut the pipe cleanly to avoid burrs or jagged edges.
3. Clean the end of the copper pipe
– To ensure a good seal use emery cloth or sandpaper to clean the end of the copper pipe. This will remove any burrs debris or corrosion that may prevent the SharkBite fitting from properly gripping the pipe.
4. Deburr the copper pipe
– Use a deburring tool to remove any sharp edges or burrs on the inside outside of the copper pipe.
5. Mark the insertion depth
– Use a Sharpie or other marking tool to mark the insertion depth on the copper pipe. This will ensure that the SharkBite fitting is properly seated on the pipe.
6. Insert the SharkBite fitting
– Simply slide the SharkBite fitting over the copper pipe push it firmly until it reaches the marked insertion depth.
7. Check the fitting
– Use a SharkBite depth gauge to ensure that the fitting is properly seated on the copper pipe. The depth gauge should align with the insertion mark made earlier.
8. Repeat steps 3-7 for all fittings
– Repeat the process for all the fittings needed.

H2: Conclusion
Installing SharkBite fittings on copper pipes is a simple straightforward process that anyone can accomplish with a few basic tools. SharkBite fittings offer a highly efficient way to join copper pipes without the use of any specialized plumbing tools or soldering. By following the above steps you can easily install SharkBite fittings on copper pipes have your plumbing project done in no time.